Types Of Work; Care And Maintenance - Hilti ST 2500 Manual De Instrucciones Original

5.2 Types of work

Warning! Risk of damage!
▶ Operation of the direction of rotation and/or function selector switch while the tool is running may
result in damage to the tool.
▶ Do not operate this switch while the tool is running.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Switching on
Note
Speed is steplessly adjustable.
▶ Slowly press down the control switch.
5.2.2 Switching on steady-state operation
▶ Hold down the control switch and press the lockbutton.
5.2.3 Switching off steady-state operation
▶ Press the control switch down further.
5.2.4 Setting the torque
▶ Turn the adjusting ring to the desired torque setting.
5.2.5 Setting forward or reverse rotation
Note
Set the forward/reverse switch to the desired direction of rotation.
To the right for "forward" (clockwise rotation).
To the left for "reverse" (counter-clockwise rotation).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.2.6 Removing screws
Note
Set the forward/reverse switch to the "Reverse" position.
▶ Remove the screw.

6 Care and maintenance

WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Printed: 09.11.2016 | Doc-Nr: PUB / 5070743 / 000 / 03
4
3
English 15