Di4 Aria Silence Control 40 Guia De Inicio Rapido página 13

- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum
distance 2 metres)
fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille; in addition,
check that the front part is free of volatile materials (dust, etc.).
• The supporting surface must be stable, flat and even (so that the appliance does not tip over).
ASSEMBLY
Warning: the fan may be used only if it is fully and properly assembled, that is to say, complete with
the base and the grille.
Warning: always disconnect the appliance from the mains supply before assembling. If in doubt,
have the operation checked or carried out by a qualified technician.
1. Insert the main stand (15) in the base (16), put the seal in place (17) and tighten it with the mounting
screw (18).
2. Raise the adjustable stand (13) and tighten the height adjustment nut (14).
3. Insert the control panel (10) into the adjustable stand (13) and tighten the mounting screw to fasten
the body to the stand (11).
4. Take the rear grille (5), place it on the motor shaft (6) and secure it in place with the rear grille
mounting nut (4).
5. Place the fan blade (3) on the motor shaft (6) and hold it in place with the mounting ring, screwing
it in an anti-clockwise direction (2).
6. Connect the front grille to the rear grille, joining them together by tightening the grille block nut (8).
USE
Before each use check that the appliance is in good condition and that the electric cable is not dam-
aged; if the electric cable is damaged, it must be replaced by the manufacturer or by the technical
assistance service or, in the event, by a qualified technician, in order to avoid any type of danger.
Insert the plug into the mains socket.
Ventilation: Select the required speed by pressing the speed selector using the following positions:
1 - Low speed 2 - Medium speed 3 - Maximum speed or select fan mode Normal / Sleep / Natural.
Similarly, you can choose to put the fan on a timer setting for 7.5 hours. This model also has a remote
control to perform all the above mentioned functions.
To turn the fan off, turn the selector to the "0" position and then remove the plug from the mains
socket.
Horizontal oscillation (right-left): this is obtained by pressing the corresponding button located on
the motor body. To stop the movement and for the fan to remain still, lift your finger from the button.
Vertical inclination (high-low): this is adjusted by holding the motor body and tilting it in the desired
direction.
During long periods of inactivity, disconnect the plug from the mains socket.
13