How To Operate - Nostalgia TCS2 Instrucciones Y Recetas

HOW TO OPERATE

Before using your GRILLED CHEESE SANDWICH TOASTER for the first time, be sure
to follow the directions under CLEANING & MAINTENANCE to clean your unit.
There may be a slight smell and some smoke the first time using
this appliance. This is both normal and temporary.
1. Place the unit on a stable surface near an electrical outlet, away from
any water source. Plug the appliance into an electrical outlet.
2. Butter the outside of two pieces of bread.
3. Build your sandwich using your favorite grilled cheese ingredients. For recipe ideas, see the
RECIPES section of this manual. When assembling your sandwich, be sure the buttered side
of each piece of bread is facing outwards.
PRO TIP: Visit the HELPFUL TIPS section of this manual for
guildelines on building the best grilled cheese sandwich.
4. Preheat the toaster by pressing down on the Control Lever, then
pressing the PREHEAT button ( ) on the Control Panel.
5. When done preheating, the Control Lever will pop up. Insert your prepared sandwich into
the Toasting Basket, then place the Toasting Basket into the Toasting Slot.
6. Depending on your preferred level of doneness, adjust the Toasting Dial to within the MELT
ZONE (levels 4 to 6) indicated on the Toasting Dial. (4 = less toasted, 6 = more toasted)
7. Press down on the Control Lever to start the toasting cycle.
8. After the Control Lever pops up, allow the sandwich to sit in the toaster for about 30
seconds before removing from the toaster. This will allow the cheese to fully melt.
NOTE: If your grilled cheese sandwich needs additional time, adjust the Toasting Dial to
between 1 to 4 and press down the Control Lever.
CAUTION! Toasted food will be hot to the touch, so handle with care.
9. When done using your GRILLED CHEESE SANDWICH TOASTER, unplug
the unit from the electrical outlet and allow to cool completely.
6