Inserting Batteries Into The Remote Control; Using The Remote Control - Essential FVPT 40 Manual De Utilización

inserting batteries into the remote control

Remove the battery compartment cover on the back of the remote control by sliding it downwards.
1.
Insert two 1.5 V AAA batteries (not included), respecting the polarities (+/-).
2.
Close the battery compartment cover by pushing it upwards.
3.
If you do not use the appliance for long time, remove the batteries from the remote control.
Do not use old batteries with new batteries or different types of batteries together.

USING THE REMOTE CONTROL

Point the remote control towards the infrared sensor located on the control panel so that the latter
•
receives the transmitted information.
Make sure that there are no obstacles between the remote control and the infrared sensor.
•
The remote control has a range of about 5 metres. Point the remote control at the unit's control panel.
•
use
Switching on the unit
1. Place the appliance on a flat, dry, stable surface.
2. Plug the unit into a wall socket. The unit will beep and go into standby mode.
3. Press the on/off button
"normal" mode at slow speed.
4. To turn off the appliance, press the
on the control panel or remote control. By default, the appliance starts in
button again.
inserting batteries into the remote control
25
V.5.0