Tools And Materials; Before You Begin - Kohler K-6284 Guía De Instalación Y Cuidado

Tanque y armazón dentro de la pared
Ocultar thumbs Ver también para K-6284:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Tools and Materials

2" Hole Bit
Assorted Drill Bits

Before You Begin

IMPORTANT! 2x6 framing is required for this product. 2x4 framing
will not be deep enough to accommodate the carriage assembly.
IMPORTANT! In areas with freezing temperatures, install on an
interior wall. If installed on an exterior wall, provide adequate
insulation to prevent the possibility of freezing.
NOTE: This device is not intended to be used as a retrofit device
for 1.28 gpf (4.8 lpf) water closets.
NOTE: Performance may vary. This product was not tested with
toilets not listed as compatible.
Only bowl numbers K-6299 and K-6300 are compatible with the
carriage.
During installation, make sure the inlet tube connections and
gaskets remain fully engaged to ensure a watertight seal.
Carefully inspect the carriage and tank for damage.
Observe all local plumbing and building codes.
For Installations with a Bidet Seat
CAUTION: Risk of personal injury. If the optional electrical
outlet will be installed, it must be connected to a GFCI or
RCD protected circuit.
1142998-2-D
Silicone Plumbers
Grease
5/8"
(16 mm)
1/2"
1/4 turn, 1/2" NPT
Supply Shut-off with 5/8"
or Shorter Handle
2
1/4" x 2" (51 mm)
Min Lag Bolts
Plus:
• Conventional
woodworking
tools and materials
• Cement board,
24" (610 mm) x
24" (610 mm) min
Optional:
• Assorted electrical
tools
Kohler Co.

Publicidad

Tabla de contenido
loading

Tabla de contenido