MAC Audio SOUNDBAR 1000 Owner’s Manual página 20

4. Select and play audio files or music on your
Bluetooth device.
During play, if a call is coming, music play is
paused. Play resumes when the call ends.
5. To exit Bluetooth, select other source.
When you switch back to Bluetooth mode,
the Bluetooth connection remains active.
Note
The music streaming may be interrupted
by obstacles between the device and the
Soundbar, such as wall, metallic casing that
covers the device, or other devices nearby that
operate in the same frequency.
If you want to connect your Soundbar with
another Bluetooth device, press PAIR button to
disconnect the current connection.
Note
This product supports LPCM.
DTS and Dolby Digital are not supported.
Please ensure that the corresponding output
is enabled in your TV's settings and that
it is set to „Stereo PCM". Also refer to the
operating instructions supplied with your TV
for further information.
Sampling frequency: 32KHz, 44.1KHz, 48KHz
Auto Standby
When playing media from a connected device,
the Soundbar automatically switches to
standby after 20 minutes if no audio play is
started from a connected device.
Applying factory settings
You can reset your Soundbar to the default
settings programmed at the factory.
On your remote control, press the LINE INPUT
button.
Press MUSIC, VOL- and NEWS on the remote
control within 3 seconds to restore the factory
default settings.
When the factory setting have been restored,
the system shuts down into standby mode and
restarts.
20