Easy Mode Card Programming - Nice MOON MORX Instrucciones Para La Installación

5.7) EASY mode CARD programming:

EASY mode programming caters for CARDS that can only activate
output N°1 or only output N°2 (STATIC 1 or STATIC 2) or, chosen by
the user, one or the other output (DYNAMIC).
The output relay is exclusively MOMENTARY.
Table "E1" Insert CARDS valid only for output N°1 (STATIC 1)
This function allows one or more CARDS valid only for output N° 1 to be inserted
Repeat the operation at any time to insert other CARDS.
1. Press the small button on the DECODER; you now have 30 seconds in which to insert the new CARDS
by holding them up to the READER.
(during this period tones will be emitted at regular intervals)
2. Pass the new CARD in front of the READER once
N.B.: Other CARDS can be inserted after the first, one after the other, repeating point 2 within a further 10 seconds
Table "E2" Insert CARDS valid only for output N°2 (STATIC 2)
This function allows one or more CARDS valid only for output N°2 to be inserted
1. Press the small button on the DECODER; you now have 30 seconds in which to insert the new CARDS
by holding them up to the READER.
(during this period tones will be emitted at regular intervals)
2. Pass the CARD in front of the READER twice
N.B.: Other CARDS can be inserted after the first, one after the other, repeating point 2 within a further 10 seconds
30
Programming in the EASY mode is activated with the small button
located on the DECODER. Only after inserting at least one CARD is
it possible to use the self-insertion procedure (table E4).
In the EASY mode, the whole memory can be deleted by pressing
the small button on the DECODER.
Example
Example
x2