Nice MOON MORX Instrucciones Para La Installación página 40

Table "F13" Programming an output in the ANTI-THEFT mode
This procedure associates the ANTI-THEFT function with the two outputs, that is,
the BISTABLE mode on output N°1 (to activate or deactivate an anti-theft system)
while output N°2 gives an impulse when the system is activated and two impulses when
it is deactivated.
Set the "timer" function to less than 0.5 seconds to return to the "momentary" mode
1. Pass the MASTER in front of the reader six times (see note)
2. Then hold the MASTER in front of the READER
3. Wait for 2 tones
4. Immediately after the second tone, remove the MASTER
N.B.: The ANTI-THEFT mode affects both outputs and therefore any MASTER can be used.
Table "F14" Programming an output in the TIMER mode
This procedure associates the TIMER function with an output and keeps it activated,
for the time pre-set (minimum 0.5, maximum 6500 seconds), after it has been enabled.
Set the TIMER to less than 0.5 seconds to return to the "momentary" mode.
1. Pass the MASTER in front of the reader six times (see note)
2. Then hold the MASTER in front of the READER
3. Wait for 3 tones (the timer starts at the third tone)
4. Remove the MASTER after the required time has elapsed (maximum 1h 50')
N.B.: At point 1 MASTER 1, MASTER 2 or the SOLE MASTER must be used depending on which output the TIMER mode is to be
associated with (the SOLE MASTER associates the mode with both outputs.) The output is activated while the time is being measured (4).
Example
GB
x6
Example
x6
39