Network Connection - Wireless - Samsung 7 Serie Manual Del Usuario

LAN Connection for Static IP Environment

The procedures to set up the network using a static IP address are described below. You have to manually enter the IP
address, subnet mask, gateway, and DNS that are provided by your Internet Service Provider (ISP).
The LAN Port
on the Wall
1. Connect the [LAN] port on the rear panel of the TV and the LAN port on the wall using the LAN cable.
You can connect the LAN via a Sharer (Router).
The LAN Port
on the Wall
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
N
If you are using a static IP address, your ISP will inform you of the IP address, subnet mask, gateway, and DNS. You must
N
enter these values to complete the network settings. If you do not know the values, ask your network administrator.
For the information on how to configure and connect a Sharer (Router), refer to the owner's manual for the corresponding
N
product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router).
N
If you use an IP Sharer (IP Router) that supports DHCP, you can set up the device as either DHCP or static IP.
N
For the procedures to use a static IP address, ask your Internet Service Provider.
N

Network Connection - Wireless

You can connect to the network wirelessly through a wireless IP sharer.
The LAN Port
on the Wall
1. Connect the 'Samsung Wireless LAN Adapter for InfoLive' into the Wiselink terminal of the TV.
You must use the 'Samsung Wireless LAN Adapter for InfoLive'(WIS-08BG) to use a wireless network.
N
The 'Samsung Wireless LAN Adapter for InfoLive' is sold separately. Contact a Samsung Electronics agent or service center
N
for purchasing.
To use a wireless network, your TV must be connected to a wireless IP sharer.
N
If the wireless IP sharer supports DHCP, you TV can use a DHCP or static IP address to connect to the wireless network.
N
You must use a wireless IP sharer that supports IEEE 802.11 B or IEEE 802.11G.
N
If the wireless IP sharer allows you to turn on / off the Ping connection function, turn it on.
N
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
N
Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is
N
currently being used by another device nearby, this will result in interference and communications may fail.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
N
1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, TKIP, AES
If you apply a security system other than the systems listed above, it will not work with the TV.
LAN Cable
1
IP Sharer
LAN Cable
LAN Cable
Wireless IP sharer
LAN Cable
English - 
TV Rear Panel
TV Rear Panel
TV Side Panel
Samsung Wireless LAN
Adapter for InfoLive