Connecting And Preparing Your Tv; Checking Parts; Using The Stand-Base; How To Assemble The Stand-Base (Depending On The Model) - Samsung 7 Serie Manual Del Usuario

Connecting and Preparing Your TV

Checking Parts

Owner's Instructions
Cover-Bottom / Screws (2ea)
(PS50A756)
Ferrite Core (Power Cord)
N
The ferrite core is used to shield the cable from interference. When connecting a cable, open the ferrite
core and clip it around the cable near the plug.

Using the Stand-Base

Two or more people should carry the PDP. Never lay the PDP on the floor
N
because of possible damage to the screen. Always keep the PDP upright.
The PDP can rotate 20 degrees in right and left directions.
N
How to assemble the Stand-Base
Using the 6 screws for securing the stand base and the monitor, firmly
attach the monitor to the stand base.
(The exterior of the set may be different than the picture.)
Warning
Firmly secure the stand to the TV
before moving it, as the stand may
fall and could cause serious injury.
N
Remote Control/
AAA Batteries (2ea)
Holder-Ring (4ea)
(Refer to page 64)
Two or more people should carry the TV.
Never lay the TV on the floor because of
possible damage to the screen.
Always store the TV upright.
Power Cord
Program CD Ferrite Core for Power
(depending on the model)
In case of installing your TV on the wall, close the
cover (1) on the stand-base connection part using two
screws for hiding.
English - 4
Cloth-Clean Warranty Card/
Safety Guide Manual
(Not available in all locations)
Cord (2ea)
-0° ~ 0°