Publicidad
Idiomas disponibles
Idiomas disponibles
May we congratulate you on your new Greenhouse
GB
Dear Customer!
The assembly of your new greenhouse
requires no technical knowledge. However, it
is important that the assembly instruction is
strictly followed. The assembly instruction is
a combination of text and illustrations.
Erect one pack at a time. All nuts and bolts
and fittings are found in bag No. 0 (specified
on page 12). Each pack is specified in
separate lists of components.
All detailed illustrations are marked with symbols:
seen from inside
seen from outside.
Precautions.
•
Assembly must only be carried out in
dry and calm weather.
•
Always use working gloves while glazing.
Greenhouse glass has sharp edges,
especially if the glass breaks.
•
Assistants and especially children must be
warned that broken glass is an element of
danger. Pick up broken glass at once and
remove it with care.
•
We recommend to use protective glasses
while fixing the spring wire clips.
•
Place the ladder on a level support.
•
It is essential to have an assistant.
References
The column marked
indicates the page(s)
on which the component is used.
Page 13:
Foundation
The base is not included in this delivery.
However, an optional base can be bought
separately. It ensures you have a stable and
easy to build base.
If you make your own base the measurements
indicated must be external measurements.
If you buy an optional base you furthermore
need about 40 litres of concrete and 3
plastic-/concrete pipes of about 800 mm
which are placed in a non-freezing depth
for the fastening of the corner and middle
anchors.
The base must be 100% level and square; the
latter is ensured by checking that the two
diagonal measurements are equal.
Tools
The mounting of the greenhouse requires
the tools shown on page 12.
Page 14-23:
Place the components as shown on the
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
Page 13:
(Fastening to the base).
When constructing your own base you
have to drill holes (7 mm) in the ground
frame between all the vertical frames, the
greenhouse is then fastened to the base with
screws (A).
Using an optional base the greenhouse is
fastened to each vertical bar as shown on
drawing B.
Fitting of glass
Important before glazing!
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
Best order of assembly:
1) Front – 2) Roof – 3) Attachment to the wall
4) Door – 5) Window - 6) Glazing
Remember to insert exstra bolts, in profile no.
931 and 932
Page 22-23:
Glazing
Degrease the sheets and frames with spirit.
Start glazing from below, one glass at a time.
Fit glazing strip (411) to all glazing bars,
gable bars and corner posts before you begin
to glaze the greenhouse.
Spring wire clips and glassholders are to be fitted
as shown.
X = Spring wire clips, > = Glassholders
Page 24: Polycarbonate installation
The illustrations at the bottom of page 24 show
where to fit the polycarbonate sheets. The type
designation states the length in millimetres. If
adjustment is necessary, use a fine-tooth saw.
NB! To avoid the growth of algae, prevent the
polycarbonate sheets from coming into contact
with the ground by resting them on a sheet of
cardboard.
If desired, the sheets may be sealed against
insects. Seal the top using aluminium tape or
silicone. The bottom should only be sealed with
air-strip tape to allow condensation to escape
(available from your local dealer).
Now your greenhouse is completely
assembled. However, please notice the
following:
Maintenance
•
Grease doors (hinges and lock or doortrack).
•
Clean the gutter for leaves, etc.
•
Adjustment of windows.
•
Replacement of broken glass.
•
Clean the greenhouse with disinfectant
before and after the growing season.
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
•
Support the roof ridge at the centre of the
greenhouse.
•
Remove greater snow loads from the roof.
B
•
Take precautions against snow falling
down from for instance a tree or a roof.
•
Dismount the cylinders for the automatic
window openers, if any (optional extras).
•
Secure door(s) and window(s) preventing wind
damage to the greenhouse.
Insurance
Please note that not all insurance companies
cover greenhouses automatically. Please
contact your insurance company to ensure
an insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. The guarantee
does not cover polycarbonate, glass, transport,
assembly, freight etc.
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting may
occur due to suspension of the profiles.
The guarantee is invalid if the greenhouse is not
assembled according to these instructions.
Complaints
All our greenhouses are built to high standards of
quality. However, should a complaint occur please
contact your dealer at once. Remember to specify
the defect by indicating the greenhouse model and
number of the component and the quality control
number.
USA
Publicidad
