Benassi FT 530 E Libro De Uso Y Mantenimiento página 25

S.p.A.
•
The machine FT530 eco is designed for an heavy duty work, mowing any kind of grass and plants also in wild areas. The easy adjustment of
the mowing height and the possibility of removing the front guard are very helpful for a professional work.
•
The machine is suitable for working in tough conditions, on hills and mountains, but without exceeding 20° in sloping grounds.
•
Through the Hand-lever Pos. B in Pict. 5, you can easily adjust the mowing height. The mowing height should be adjusted according to the
kind of grass, the ground conditions, and the needs of the operator.
•
For the first minutes after starting the machine, keep the engine at a medium speed, and be careful and slow in doing the first manoeuvres.
•
When the transmission belt is skidding, and th wheels are not turning, with the clutch lever on ( Pos. A in Pict.5),you should adjust the belt-
tightener (Pos. B in Pict.7).
•
In any case, make sure that the belt (Pos. A in Pict.7), should not be too tight.
ADJUSTMENT OF THE TRANSMISSION BELT.
1. After unscrewing the 4 screws, remove the front guard ( Pos. B in Pict.6).
2. Loosen the nut Pos .C in Pict. 7, using a spanner size 17, and let the screw supporting the belt-tightener ( pos. B in Pict.7), until the belt is
properly tight.
3. Block again the Nut ( Pos. C in Pict 7) in the correct position
The adjustment of the belt-tightener should be regularly done, and the transmission belt should be always perfectly aligned, and tight.
•
For the adjustment of the driving levers on the handlebar, and the relative cables, please check the second Chapter
ASSEMBLING .
•
For mowing very high and strong grass, you can remove the side conveyor (Pos.A in Pict.8), and also the front guard (Pos. B in Pict.8), after
unscrewing the fixing screws. Before doing this job, please make sure that the engine is off, and the spark plug disconnected.
•
IMPORTANT ! The operator must be aware that the machine at work could throw out stones and other dangerous things. He should always
make sure that the working area is free, for a minimum radius of 50 metres in any direction .It is recommended to delimit the working area
with safety stripes,and signals of danger.
•
Working in extreme conditions, with very high and strong grass, it could happen that the blade is blocked by the grass. In this case, you can
increase the mowing height, and reduce the working width of each passage.
•
If you need a Mulching effect, you should leave the mowing deck closed, with the protection guards mounted.
•
When you are driving the machine near a wall or a stoned path, be very careful, because it could damage the blade.
•
For moving the machine Forward and Backward with the engine OFF, please don t push the clutch lever ( Pos. A in Pict.5).
•
The front little wheel is normally turning at 360°, and it is mounted with a pin ( included), as shown in Pict. 9, Pos. A. In case you want it
fixed, you can block it, mounting the pin as in Pict.9, pos.B.
•
The machine must be always used in the full respect of the safety rules listed in this manual.
•
It is recommended to use the machine in the daylight, or with good artificial lighting.
CAUTION
It is advised not to keep the motor running when the machine is not being used for its specific purpose
MAINTENANCE
FT 530 E
PACKING AND
25