Transport And Assembly - Steelcase Partito Wall Guía Rápida

Electrical system:
Incoming and outgoing cables can be routed via the open side. This enables accommodating up to 8 cables of an 8-mm cross-section each. The
cables can also be routed from the vertical cable duct into the horizontal cable duct or vice versa. An appropriate section of the cable duct cover
can also be cut out as an option for a cable outlet.
Opening/Closing of cable duct Reading the product label:
Unlock the 4 slides (marked in the figure) on the cable duct cover

Remove the cable duct cover

Attach the cable duct cover

Lock the 4 slides (marked in the figure) on the cable duct cover


5. Transport and assembly

Check the delivery contents:
After unpacking, check the product immediately for damage sustained during transportation and for completeness; inform the manufacturer of
any damage as soon as possible.
Partito Wall:
Assembling the
For assembling specific parts at the Partito Wall, please follow the attached assembly instructions.
145000
The CE mark is located on the optional multiple socket outlet. The multiple socket outlet
can be located on an adjoining desk or in a cable duct of the Partito Wall. Compliance with
the information under the section "Opening/Closing of cable duct" is required for
opening the cable duct.
The product label is located at the underside of the
Partito Wall feet where its information can be read.
To open and subsequently close the cable ducts proceed
as follows:
P a r t i t o W a l l
EN
Rev. A