Sapphire Scientific Upholstery Pro F436-P Instrucciones De Uso

The Upholstery Pro cleaning tool provides deep, rapid penetration of cleaning solution and
simultaneous high volume extraction. Lightweight, easy to use, and adjustable for a wide range of
fabrics and soiling conditions, the Upholstery Pro produces cleaner, drier fabrics.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
KEY FEATURES
 Comfortable handle and highly flexible vacuum hose
provides relaxed balanced handling and substantially
reduces operator fatigue.
 In-line solution strainer helps prevent clogging.
 High pressure injector glide provides deep, even
penetration of solution into fabric surface.
 Unique dual extraction slots permit full extraction in
both directions across fabric surfaces
 Sliding vacuum release allows for precise vacuum
control on delicate fabrics.
 Clear housing for easy monitoring of water flow, fabric
or carpet dryness, and cleaning effectiveness.
USING THE UPHOLSTERY PRO
1. Connect the rear quick-connect solution line to the
extractor solution line
2. Attach the rear hose coupling to the extractor vacuum
port.
3. Turn on extractor.
4. Squeeze the trigger lever to release the solution and
begin cleaning. The sliding trigger lock may be used
to hold the trigger valve in the open position.
FIG. A: HEAD, VACUUM HOSE AND
SOLUTION LINE ASSEMBLY
Vacuum
release slide
07-02087B F436-P
User Instructions
Upholstery Pro
Model F436-P
Patents: http://www.LBpatents.com
Solution line
quick-connect
coupling. See
Fig. D for
parts detail.
Rear vacuum hose cuff.
Solution trigger lever.
5. Use the vacuum release slide (Fig. A to adjust the
strength of the vacuum as needed.
WARNING: Quick-connect coupling
can become extremely hot during
use.
Tips for Use
Vacuum control. Use the vacuum release slide (Fig. A)
to control the strength of the vacuum when extracting
thin, delicate or lightweight fabrics.
For best results, use the Upholstery Pro with Legend
Brands cleaning chemicals.
For more information about cleaning with the Upholstery
Tool, visit LegendBrandsCleaning.com.
MAINTENANCE
Daily: Rinse the hand tool by running clean water
through the solution line.
Daily: Check the glide assembly (Fig. A) for steady,
even flow of solution through the injector nozzles. If any
of the injector ports appear clogged, use a small needle
to remove the obstruction, taking care not to damage the
glide. If the glide is scratched, gouged, snags on
carpets, or flows excessively, it may need to be
replaced (see "Servicing the glide," below).
Replacement glide assemblies are available from
your distributor.
As needed: Lubricate the quick-connect
couplings (Fig. A) with a small amount of rust-
inhibiting oil such as LPS-3.
As needed: Lubricate trigger valve stem (Fig.
C) with a small amount of synthetic heavy duty
grease. To grease the stem, follow these steps.
1. Remove the trigger lever nut and bolt from the
trigger lever and remove lever.
2. Unscrew stem retention nut and lift out stem
assembly. Apply a small amount of grease to the
stem.
1 Sapphire Scientific