CP B Serie Manual De Usaro página 3

ECLA1 - ECLA3 - ECLA5 - ECLA8 - ECLA11
DECLARATION OF USE
"Class I" tool. Tool suitable for industrial environment only. It shall be
used for tightening or loosening joints in wood, metal or plastic
material. No other use will be permitted.
OPERATING MODE
The tool is a portable angle wrench.
Fit the tool with a suitable fastening accessory, then connect it to the
power supply by means of the controller.
Deselect the PUSH START mode through the CVIC controller.
Select the tightening cycle through the CVIC controller.
Hold the tool by means of the handle and apply to the fastener to be
tightened.
Press the trigger.
For a reversed rotation, hold the direction reversal button down, then
press the trigger.
As the reaction force increases in proportion to the tightening torque,
make sure that the tool is in perfect working order and the controller is
programmed correctly, to reduce the risk of injury to the operator as a
result of unexpected behaviour of the tool.
Control and software
Power supply by means of CVI-C 2 controller fitted with a program
version 2.1.
ASSEMBLING AND DISASSEMBLING
Follow standard engineering practices and refer to figure for the
mounting of component sub-assemblies.
Meaning of the pictograms
Left hand thread.
When reassembling, apply the recommended
glue
When reassembling, tighten to the required torque
When reassembling, lubricate with the required
grease
LUBRICATION
Do not apply too much grease on gears or bearings; a thin coat
shall be sufficient.
Apply a minimum quantity of grease for easier identification of
components when assembling.
Manufacturer
KLUBER grease Isoflex NBU15
Specific tools
Spanner wrench
Flat wrench 34
Bevel gear extractor
ECLA11
Bevel gear nut extractor
MAINTENANCE INSTRUCTIONS
Maintenance should be performed by qualified personnel only.
• Prior to any maintenance task: disconnect the tool
• When disassembling / reassembling the tool, take the following
precautions:
• Check that the controller is switched off
• Disconnect the cable
• To avoid damaging the tool during disassembly, use the
recommended tools.
• When disassembling the handle, be careful not to pull on the electric
wires that are connected to the motor.
• Any repair on the motor shall be carried out in our workshops.
• Check that components are in good condition and apply grease on
mechanical parts every 500,000 tightening cycles.
• As specific adjustment tools are necessary to replace the angle
head bevel gears, it is recommended to replace the angle head for
a complete shop-adjusted subassembly.
• The bevel gear should be cleaned and relubricated every 100 000
cycles for maximum service life.
When disposing of components, lubricants, etc ... ensure
that the relevant safety procedures are carried out.
© Copyright 2007, GEORGES RENAULT S.A.S, 44230 France
All rights reserved. Any unauthorized use or copying of the
contents or part thereof is prohibited. This applies in particular
©
to trademarks, model denominations, part numbers and
drawings. Use only authorized parts. Any damage or
malfunction caused by the use of unauthorized parts is not
covered by Warranty or Product Liability.
6159935940-01
Serie B
3 / 16
Part number
6159901510
Part number
6158020110
6158010800
6159611380
6159610370