Recommended Accessories; Basic Operation - AGP G5 Instrucciones De Seguridad

GB
Side Handle..........................................1
Lock Nut Wrench................................1
Face Spanner Wrench .......................1
L-Hex Wrench.......................................1
Flanges...................................................2

RECOMMENDED ACCESSORIES

This machine may only be used with diamond cup wheels of 125mm diameter for G5 and 180mm for SM7
with 25.4mm (1") or 22.23mm (7/8") arbor hole or with M14 female thread.All other uses are prohibited.
Bonded abrasive accessories are not allowed to be used with this machine.

BASIC OPERATION

NOTE: Make sure that the power circuit voltage is the same as that shown on the specification plate of
the machine and that switch is "OFF" before connecting the tool to the power circuit.
THE SWITCH
The machine has a lockable trigger switch. Squeeze the trigger to
Trigger Switch
start the machine. To lock the switch on, press the lock button while
holding the trigger switch on.
To release, squeeze the trigger and release.
CAUTION: After the machine has been switched off, the spindle
will continue rotating. Take care that parts of your body do not
come into contact with the rotating parts or set the machine
down while it is still rotating!
HOW TO USE THE TOOL
Effective control of this machine requires two-handed operation for maximum protection and resistance to
the start-up and operating torque. Place the work properly and hold the machine firmly WITH BOTH HANDS
to prevent loss of control, which could cause personal injury. Protect your eyes from injury with safety glasses
or goggles.
OVERLOAD
This machine is equipped with overload protection which will shut off the motor if the maximum allowable
current is exceeded. If the overload trips, remove from the work surface, release the switch and then switch
back on. The machine will restart.
CAUTION: Whenever the machine overloads, always run the machine at no load for a few minutes to
allow the temperature to return to normal before proceeding to work.
11