Tool Change - AGP G5 Instrucciones De Seguridad

TOOL CHANGE – Removing and Replacing Diamond Cup Wheel
CAUTION: Before Working on or adjusting the machine, switch the machine "OFF" and UNPLUG machine
from the socket.
CAUTION: The wheel can become very hot during the working process. Before replacing, allow the
wheel to cool down
1.
Place the machine on a level and sturdy workspace.
2. If using a diamond cup wheel with M14 female thread, do not use the flanges. Simply thread the wheel
onto the spindle. Use the L-Hex Wrench to keep the spindle from turning and tighten the wheel using
the Face Spanner Wrench.
3.
If using a diamond cup wheel with arbor hole, first mount the inner flange onto the spindle. On the SM7 it
is 22.23mm only. On the G5, it is 22.23mm on one side and 25.4mm on the other. Mount the wheel onto
the shoulder of the Inner Flange, then thread on the Arbor Nut. Use the L-Hex Wrench to keep the
spindle from turning and tighten the Arbor Nut with the Lock Nut Wrench.
4.
Replacement is the opposite of removal.
INSTALLING DIAMOND CUP
WHEELS W/ M14 FEMALE THREAD.
Face Spanner Wrench
STORAGE
CAUTION: Do not store machine resting on its bristles – Store on its side.
CAUTION: Do not store machine with its power supply cable pinched. This will result in damage to the
cable.
GB
L-Hex Wrench
13
INSTALLING DIAMOND CUP
WHEELS WITH ARBOR HOLE.
Lock Nut Wrench L-Hex Wrench
Arbor Nut
Inner Flange