Samsung DV455 Serie Manual Del Usuario página 36

Operating instructions, tips
Connecting to the network using the WPS setting
Your Samsung dryer uses Wi-Fi Protected Setup/Push Button Confi guration WPS(PBC) as
the primary method of connecting to a wireless router or modem. If your router or modem
is WPS compliant and has a WPS button, you can easily connect your dryer to your router/
modem.
1. Press and hold both the Temp. and Start/Pause buttons
for 3 seconds.
2. Turn the Cycle Selector until "UP" is displayed on the
display panel, and then press the Start/Pause button.
If the connection is not established within 5 minutes,
"FUP" is displayed on the display panel.
3. Press and hold the WPS button on the wireless router/
modem within 120 seconds to run the WPS function.
If the WPS function runs, the wireless router/modem
automatically fetches the necessary information from the
dryer and the dryer is automatically connected to the
Internet through the wired/wireless router/modem.
•
•
•
CAUTION
•
4. If the dryer and the wireless router/modem are properly
connected, the
30 seconds.
5. Press and hold the Signal On/Off button for 3 seconds
to fi nish the Smart Control connection setup. When the
setup is completed normally, the
display panel accompanied by a beeping sound.
If you press and hold the Signal On/Off button for 3
seconds when the dryer and the wired/wireless sharer
are not properly connected, the invalid button sound
is heard and the Smart Control connection setup is
not completed.
DV455_02836F-08_EN.indd Sec3:36 DV455_02836F-08_EN.indd Sec3:36
The way the WPS function runs on your wireless router/modem may diff er
depending on the manufacturer. Refer to the user manual of your router/modem for
details.
Even after the WPS setup is complete, it may take some time until the actual
connection is established and an IP address is allocated through through DHCP (up
to 5 minutes).
Note that if you use a wireless router/modem that is not WPS-certifi ed, the dryer
may not be connected through Wi-Fi or another device that was connected to the
wireless router/modem may be disconnected.
Please note that for some wireless router/modem, if you press and hold the WPS
button for some time, the settings of the router/modem may be reset.
indicator blinks on the display panel for
indicator blinks on the
English - 36
2013-12-12 2013-12-12 5:11:59 5:11:59