Removal From Window - Kenmore 580.75062 Manual Del Propietário

Acondicionador de aire de ventana
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

D
IF AIR CONDITIONER
IS BLOCKED BY
STORM
WINDOW
FRAME
• If storm window
presents
interference,
fasten a
2"(51mm)
wide wood strip to the inner window
sill
across
the full width of the sill. The wood strip should
be thick enough
to raise the height of the window
sill
so that the unit can be installed without
interference
from the the storm window
frame. See FIG. 10.
Top of wood strip should
be approximately
3/4"(19mm)
higher than the storm window
frame to
help condensation
to drain properly
to the outside.
• Install a second
wood strip (approximately
6"(152mm)
long by 11/2"(38mm)
wide and same
thickness
as first strip) in the center of the outer sill
flush against the back of the inner sill. (FIG. 10)
WOOD STRIPMOUNTED
ON TOPO_
SILL
_/_V_/O/_/SS/T/_
INDO0_
1 1/2" rnin.
3/4"(19mm)
(38mm)
CLEARANCE
o-
,
STORM
_
WINDOW
/J_/_ FRAME
//}/
OUTER
_//
SILL
_//
OUTDOOR
When storm window
frame is located on outer sill
FIG. 10
D
INSTALLATION
FOR OTHER TYPE
WINDOWS.
• Dimensions
and geometry
of windows
are different
according
to manufacturers.
Check
your window
and refer to FIG.11
to install the support
bracket
firmly.
(a) When window
frame is located
on inner
sill,
• Install a wood strip (window width long and
window frame height high) on the inner sill.
SASH WINDOW
_-_
WINDOWFRAME_.
WOOD STRIP
_///////////////_ O UTDOOR
(b) When the window frame is higher than
19/32"(16mm)
• Install a wood strip (about 4"(102mm) long) on the
outdoor sill to raise support bracket,
WINDOWFRAME_
FWOODSTRtP
19/32"(1_
'NNFLR_
_///////////////_ O UTDOOR
BILL
FIG. 11
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• Unscrew the side screws that you installed in Step 5.6.
• Close the curtain frame and remove foam seal and L
bracket from the windows.
• Keep a firm grip on the air conditioner
raise the sash.
• Lift the air conditioner from the window and remove the
foam strip from between the windows.
• Remove the support bracket from window frame.
NOTE: When cooling season is over, unit is removed
from window for cleaning and storage. There may still be
some condensation
water in the basepan. Remove the
unit carefully to avoid water being spilled out on floor,
always store unit fiat on its base. Do not stand on end. Be
sure to remove support bracket, L bracket, and foam seal
from window and save. Window will not close if support
bracket remains installed.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido