While Operating; Maintenance And Cleaning; Technical Assistance - VITO PRO-POWER VIASC18A Manual De Instrucciones

EN
accessories are correctly assembled
and in good condition. Never use
damaged accessories;
� Check that all nuts and bolts are
properly tightened. A regular overhaul
is important to ensure safety and
performance of the power tool;
� Check if the safety devices are
in perfect conditions and working
correctly. Never use the machine if
any safety device is missing, inhibited,
damaged or worn;
� Make sure that the switch is off when
you plug in the power cable. If the
button is damaged or doesn't allow to
control the machine's operation, it must
be repaired or replaced in order to
prevent an unintentionally start;
Perform all the needed adjustments
and in case of doubts ask your
distributor for assistance.

2.4 - WHILE OPERATING

Keep other people away from
the workspace. Never use the
machine if animals
particularly children, are nearby.
The clothing worn while operating
the machine must be appropriate and
tight, such as a work coverall. Do not
wear loose clothing or jewelry. Keep
hair, clothing and gloves away from the
moving parts.
Keep the workspace clean, organized
and well illuminated in order to reduce
the risk of accidents.
Do not cover the power tool during
use. To avoid the risk of electric tool
heating, always keep the ventilation
outlets clean and unobstructed to allow
air circulation.
2.5 - MAINTENANCE AND
CLEANING
Before cleaning, adjusting, repairing
and maintenance works, the power
cable must be unplugged.
Replace worn or damaged parts
immediately, so that the machine is
always in a safe operating condition.
Cleaning:
The machine must be carefully cleaned
after each use.
Do not use aggressive cleaning
products. These products may damage
plastics and metals, compromising the
safe operation of the machine.
Maintenace:
Only maintenance works described in
this instruction manual may be carried
out; all other works must be performed
by an official distributor.
Keep all the nuts and screws well
tightened in order to ensure a safe
operation.
If any components or safety devices are
removed for maintenance works, they
must be repositioned immediately.
or people, The maintenance of machines with
double insulation requires an extreme
care and knowledge of their system,
and should only be performed by
a qualified
components of a double insulated
power tool must be done with the same
parts as the original ones.
Use only VITO-approved tools for this
machine or technically identical parts.
Not doing so may result in personal
injuries or damages to the machine. In
case of doubt, you should contact an
official distributor.

2.6 - TECHNICAL ASSISTANCE

The machine must be repaired only by
the brand official technical service or
by qualified technicians and only with
original replacement parts.
technician. Replacing
3. ASSEMBLY
INSTRUCTIONS
3.1 SUCTION HOSE AND PIPE
ASSEMBLY (FIG.B)
1. Insert the suction hose (2) into the
suction hose connector;
� To vacuum, fit the hose in the suction
hose connector (3);
� To blow, fit the hose in the air outlet
connector (16);
2. Spin it clockwise to fit the hose;
3. Check if the hose is well tightened;
4. Insert the suction pipe (1) into the
hose fitting;
To remove the suction hose:
5. Spin it counter clockwise and
remove the hose;
3.2 HEPA FILTER ASSEMBLY
(FIG.C)
Never operate this equipment without
the HEPA filter. This filter avoids the
entry of ash and dust preventing the
engine from failing.
1. Unlock the cover fasteners (8) and
remove the cover (4);
2. Install the HEPA filter (11) in the
engine base (12);
3. Tighten the fixing screw (13) of the
HEPA filter;
4. When the HEPA filter is installed and
well tightened, the safety switch (14) is
pressed;
5. Place the cover and lock the cover
fasteners;
25