Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Speaker Connection
Route speaker wire and cut to desired length. Connect to speak-
ers observing correct polarity. Strip insulation about ¼" from the
end of wire. Insert wire into green speaker connector and use
small screw driver to tighten. Once all 4 wires are connected, plug
green connector into mating connector on rear of keypad. Makes
sure no bare wires touch each other.
Power Connection
Route the 12V DC power wire from AC outlet to wall box for keypad.
Connect to 2-pin connector labeled LN12V on rear of keypad.
Make sure that power is off when making Speaker connections.
Wall Box Installation
4.08in. (103.6mm)
3.28in. (83.3mm)
Remove front faceplate by unsnapping four tabs from the rear
Route the FM antenna through an opening in the wall box so that
AUDIO
AUDIO
DC POWER
Publicidad
