Special Safety Instructions - VONROC CR501AC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
EN
temperature range specified in the instructions.
Charging improperly or at temperatures outside
the specified range may damage the battery and
increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.

SPECIAL SAFETY INSTRUCTIONS

• Warning! The compressor may only be used in
suitable rooms (with good ventilation and an
ambient temperature from 0°C to +40°C).
• Do not perform any actions on the compressor
without first having taken the plug out of the
plug socket.
• Do not aim water jets or jets of flammable
liquids at the compressor.
• Do not place flammable objects near the com-
pressor.
• Switch the switch (3) to the "0" position (OFF)
during dwell time.
• Never aim the air jet at persons or animals.
• N.B.: some parts of the compressor such as the
head and the feed-through pipes may reach
high temperatures. Do not touch these parts to
avoid burns.
• Transport the compressor by lifting it or by using
the special grips or handles.
• Children and animals should be kept far away
from the area of operation of the machine.
• If you use the compressor to spray paint:
a) Do not work in enclosed spaces or near
naked flames.
b) Make sure that the environment in which you
will be working has dedicated ventilation.
c) Protect your nose and mouth with a dedicat-
ed mask.
• Do not use the compressor when the electrical
cable or the plug is damaged, and instruct an
authorised Support Service to replace them with
an original part.
• When the compressor is placed on a surface
higher than the floor, it should be secured to
prevent it from falling down during operation.
• Do not put objects or your hands in the pro-
6
tective covers to avoid physical damage and
damage to the compressor.
• Do not use the compressor as a blunt instru-
ment against persons, objects or animals in
order to prevent serious damage.
• If the compressor is no longer in use, always
take the plug out of the plug socket.
• Always make sure that compressed-air hoses
are used for compressed air and which are
characterised by a maximum pressure adjusted
to that of the compressor. Do not try to repair
the hose if it is damaged.
SAFETY INSTRUCTIONS FOR WORKING WITH
COMPRESSED AIR GUNS
• The compressor and hoses can get very hot dur-
ing operation. Touching them can cause burns.
• The gases or vapours sucked in by the com-
pressor intake must be kept free of admixtures
that could lead to fires or explosions inside the
compressor.
• When removing the hose coupling, always hold
the hose coupling firmly to avoid injury caused
by the hose flying off .
• When working with the blow-out gun, wear
goggles. Foreign bodies and blown out particles
can easily cause injuries.
• Do not direct the blow-out gun at people or use
it to clean clothing you are wearing.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions.
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is danger-
ous to insert the plug of a loose cable in the wall
outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm2. When using a cable reel
always unwind the reel completely.
WWW.VONROC.COM

Publicidad

Tabla de contenido
loading

Tabla de contenido