Jacobsen MagKnife LMAC128 Instrucciones De Montaje página 3

Preparation
1. Refer to your product manuals and remove
cutting units from mower. Move cutting unit to
workbench.
2. Remove existing Bottom Block and Blade
assembly.
a. Take unit off cut.
b.Remove screws B and C and remove existing
Bottom Block and Blade assemby.
c. Check cutting cylinder for bearing end play.
Replace components as required.
Assembly
1. Fit new MagKnife assembly A into cutting unit
frame.
2. Secure using screws B and C
3. Adjust the cutting cylinder to the bottom blade
as described in your product manual.
NOTE: It is optional to backlap the new MagKnife.
The magnets bring the blade into close enough
tolerance that backlapping may not be
required.
4. Fit Warning decal H to cutting unit top cover
next to the Caution, Rotating Blade decal.
5. Fit MagKnife decal G to cutting unit top cover.
3