Using The Powerlink 4; Basic Setup And Use; Linking With Ablenet Wireless Devices - AbleNet PowerLink 4 Manual Del Usuario

Using the PowerLink 4

Basic Setup and Use

1. Plug the PowerLink into any AC wall outlet with the cord provided and turn the device ON.
2. Plug appliance(s) to either power cable on the side of the PowerLink and turn the
appliance(s) ON.
Note: For pressure sensitive switches, consider tape or a Velcro® strap to hold the
button down.
3. Test your AC power connection by pressing the appropriate Test button. The attached
appliance should activate.
4. Attach any corded, single switch(es) to the corresponding switch jack(s)
5. Press the Mode button until the "Direct" mode LED lights up.
6. Press and Hold switch(es) to activate their corresponding appliances. Release to turn OFF.
PowerLink's Status lights will activate and remain on whenever the PowerLink receives
switch input.

Linking with AbleNet Wireless Devices

The PowerLink can be controlled by any AbleNet Wireless* transmitter such as the Jelly Beamer®
wireless switch. Linked devices can access the PowerLink from up to 30 feet away without pointing
or "line of sight".
Up to 8 wireless switches can be linked to one or both sides of the PowerLink, and will only activate
sides that they are linked to.
To link wireless switches:
1. Turn both the PowerLink and wireless switch ON.
2. Press and Hold PowerLink's Status button on the side you wish to link for
6-10 seconds until the light turns solid Green.
3. Activate any AbleNet Wireless transmitter.
PowerLink's corresponding light will blink Red, then Green.
Repeat this step to link as many as 7 additional transmitters on that side.
4. Press and Release Status button to exit linking mode.
PowerLink's corresponding light will turn off.
5. Repeat steps 2-4 for opposite side.
NOTE: Once you exit linking mode, re-initiating the linking process will overwrite
all previously linked devices.
To un-link wireless switches:
Press and Hold the desired Status for 10-15 seconds until the light blinks Red
3x, then Green, then off.
*AbleNet Wireless refers to devices using the AbleNet Wireless protocol and does not include Bluetooth™ devices such as the Impulse™
EMG switch, or infrared devices such as the AirLink® cordless switch. For a complete list of AbleNet Wireless switches, visit
www.ablenetinc.com/wireless or contact AbleNet customer service.
.
5