Porter & Cable 7800 Manual De Instrucciones página 9

CONNECTING THE SANDER TO YOUR SHOP VAC
Furnished with the Drywall Sander are:
• A 13' (396 cm) long vacuum hose. This hose has a standard 1-1/4" (3.2 cm)
vacuum cleaner connector on one end and a special swivel connector on the
other end. It has a static dissipating feature to dissipate static electrical charges.
• A drywall sander adaptor allows connection to a D
INSTALLATION
To reduce the risk of personal injury, use a dust bag rated for
drywall dust. Failure to do so will increase the level of airborne dust particles
in the work area. Continued and prolonged exposure to high concentrations
of airborne dust may affect your respiratory system function.
FOR USE WITH PORTER-CABLE 7812 VACUUM (FIG. 2)
1. Install the special drywall dust bag into your vacuum cleaner, following the
instructions supplied with the vacuum cleaner. If this dust bag does not fit your
vacuum cleaner correctly, purchase and install a suitable filter bag that is rated for
drywall dust.
2. Connect the vacuum hose to the
Drywall Sander. Open the hose
connector by turning the large nut
(C) counterclockwise a few turns.
Push the vacuum hose swivel
connector (B) into the connector
and seat firmly. Turn the large nut
clockwise to tighten the connector.
3. Connect the vacuum hose to your
vacuum cleaner. Use the 1-1/4"
(3.2 cm) to 2-1/2" (6.4 cm) adaptor if necessary. If your vacuum cleaner requires
a special connector (something other than the standard 1-1/4" (3.2 cm) to 2-1/2"
(6.4 cm) connectors supplied with the Drywall Sander), contact your vacuum
cleaner supplier for the proper adaptor.
FOR USE WITH D WALT DWV012 VACUUM (FIG. 3, 4)
E
1. Remove the large nut (C) and ring (D) from the drywall sander (E). Save these parts
for future use.
FIG. 3
D
C
2. Thread drywall sander adaptor (F) onto drywall sander.
3. Attach twistlock end of vacuum hose to drywall sander adaptor (F). Twist collar
(G) to lock into place.
FIG. 2
B
FIG. 4
E
9 - ENG
WALT DWV012 vacuum.
E
G
F
C