Connect Modem/Phone/Network For Surge Protection - Nilox UPS SMART SERIE Manual De Usuario

Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Please place the UPS away
from other units at least 20 cm to avoid interference. Do NOT operate the UPS where the temperature and humidity is
outside the specific limits. (Please check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results, suggest to charge the
battery at least 4 hours before initial use. The unit charges its battery while connecting to the
utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power switch of UPS unit, then
devices connected to the UPS will be protected by UPS unit.
CAUTION: NEVER connect a laser printer or scanner
to the UPS unit. This may cause the damage of the unit.

Connect Modem/Phone/Network for Surge Protection

Connect a single modem/phone line into surge-protected "IN" outlet on the back panel of the UPS unit. Connect from
"OUT" outlet to the computer with another phone line cable.
Connect Communication Cable
To allow for unattended UPS shutdown/start-up and status monitoring, connect the communication cable one end to
the USB/RS-232 port and the other to the communication port of your PC. With the monitoring software installed, you
can schedule UPS shutdown/start-up and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power switch.
(Only for the model with USB/RS-232 port)
(Only for the model with RJ-11/RJ-45)
4 hours