Manual Backwashing - Toro Aqua-Clear Guía De Instalación Y De Usuario

12. Pressure Units
Select PSI for US units, or Bar for metric units.
13. Calibration
This will calibrate the PD sensor. While the controller sensor ports are disconnected from the
hydraulic tubing, select the Calibration = Yes. The calibration occurs very quickly, and the
sensor ports on the controller should be reconnected after passing through this program step.
This will conclude the programming of the controller, and it is ready to use. If you want to revisit
any of the settings, simply cycle through them at this point. If you wish to change setting 1-4,
briefly press the ENTER key. If you wish to re-visit steps 5-13, press and hold the ENTER key
for at least 3 seconds.

Manual Backwashing

A flushing sequence can be manually triggered by the MANUAL key (hand
Icon, or M). By pressing the MANUAL key again the cycle will be
M
terminated.
Figure 10
Manual Key
symbols
Aqua-Clear Automatic Backwash (ENG/SPA) pg. 15