About Installation - Great White GW9500 Owner’s Manual

Please use the convenient, water resistant, "EASY-STEPS" card.
Step 1: Install vacuum port door fitting
If there is no spring-loaded door on the vacuum port,
install the included cover.
If you pool only has a skimmer, and no dedicated vacu-
um port, proceed to Step 2.
Figure 1
1. Screw the fitting into the port opening.
2. Orient the fitting so the arrow on the door points up.
3. Secure the cover by tightening the allen-screw below the
door.
Step 2: Straighten hose (Figure 2)
Remove and uncoil the hose from the carton. Lay it out
in the sunlight, flat and straight.
Figure 2
Step 3: Check parts (Figure 3)
• Cleaner assembly
• Black plastic swivel assembly
• Handle adapter
• White rubber reducer cone
• Hoses: 20', 8' and 4'
• White plastic vacuum regulator
• Cap for regulator
• Vacuum port fitting
• Flow gauge

ABOUT INSTALLATION

Figure 3
Step 4: Clean filter system (Figure 4)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
Figure 4
Step 5: Adjust valves for vacuuming (Figure 5)
Decide on the vacuum connection you are going to use
(either a skimmer or a dedicated wall fitting) and adjust
the pump valves (if your system has valves) to direct all
1882 0795
vacuum there.
Close the main drain (also see "About Fine Tuning the
Vacuum", Page 6).
Figure 5
3
Cleaner
Handle
Hose
4'
8'
20'
Vacuum
Port
1902 0795
Vac
Port
Swivel
Reducer
Ass'y
Cone
Flow
Gauge
Regulator
Regulator
Cap
1880 0795
Skimmer