Hose Connections; About The Cleaner Operation - Great White GW9500 Owner’s Manual

Follow drawing that most closely resembles your skimmer installation.
Water
A
Level
Vacuum
Regulator
Reducer
Cone
Skimmer
Port
Gate valve for
skimmer must
be fully open
Clicking sound
This sound is the oscillator moving back and forth in the
oscillator chamber. The best speed for it is about 500
oscillations per minute. The vibration created by the
oscillator moves the bristles and the cleaner. If the oscil-
lator is running too fast, the cleaner will have a tendency
to climb up the pool wall past the waterline, or "walk
out of the pool".
Movement around the pool
Random motion – The cleaner will visit most spots in the
pool in a 6 hour period. It is not specifically programmed
and cannot see the dirt you are seeing. It is a random
motion cleaner.
The cleaner was designed to spend most of its time in
the deep end, where most of the floor and wall area
exists. During a 6 hour period the cleaner will visit the

HOSE CONNECTIONS:

ABOUT THE CLEANER OPERATION:

Vacuum
B
Regulator
with Cap
Reducer
Cone
Skimmer
Gate valve for
vacuum port must
be fully open
shallow end a few times.
Rotating motion – The cleaner will rise up on one side
and pivot a few times per minute. This is normal and
provides the following:
1. Allows leaves that are being pushed or dragged along to
be sucked up into the vacuum chamber.
2. Allows the cleaner to:
Change direction
Get out of corners
Get away from ladders
Submerge below pool water level
Get off of domed main drain covers
Picks up big "stuff"
The cleaner will pick up some debris so large that it may
jam. Simply stop the pump and remove the debris from
the oscillator or the swivel assembly.
5
Water
Level