Campbell Hausfeld WT6100 Manual De Instrucciones

Operating Instructions
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
BUILT TO LAST
Figure 1 - Welder Components and
Controls
Description
The WT6100 TIG torch allows you to
convert your Arcitech 110 inverter
technology welder to a TIG (GTAW)
welder. TIG stands for Tungsten Inert
Gas. GTAW is Gas Tungsten Arc
Welding. TIG is also commonly call
Heliarc ® welding, but Heliarc
name of the Linde Company, not a
process. Heliarc ® comes from Helium
Arc Welding, as helium is an inert gas
used to keep impurities from the weld.
Today most TIG welding is done with
100% Argon shielding gas.
TIG welding gives the most beautiful
and clean welds with the most
precision and control. It is the best
process for welding dissimilar size items
together. The drawback to TIG welding
is that it takes a high skill level, and it is
slow.
TIG welding is often used in welding
Aluminum, however welding
Aluminum with TIG requires an AC
high frequency power source. The
Campbell Hausfeld Arcitech 110 has DC
only output, so it can not weld
Aluminum with the TIG process.
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
© 2003 Campbell Hausfeld/Scott Fetzer
2
Figure 2
Unpacking
When unpacking, inspect carefully for
any damage that may have occurred
® is a brand
during transit. Make sure any loose
fittings and screws, etc. are tightened
before putting unit into service.
WARNING
!
(has current potential) when machine is
turned on.
Components of the WT6100
TIG Torch:
1. 2% Thoriated Tungsten Electrode -
1/16" (1.6 mm)
2. Nozzle #7 use with 1/16" (1.6 mm)
electrode
3. Collet Body - match to electrode size
(1.6 mm)
4. Collet - matched to electrode size
(1.6 mm)
5. Insulator
6. Torch Head
For parts, manuals, product & service information
visit www.chpower.com
TIG Torch
5
4
3
1
The electrode
holder is "live"
or call 800-746-5641
Model WT6100
8
8
6
10
12
11
Figure 3
7. Gas Valve
8. O-rings (for gas valve and back cap)
9. Back Cup
10. 12.5' Torch hose
11. Dinse plug power connector
(connect to negative (-) output on
welder)
12. Gas connector (connect to gas
regulator on 100% Argon tank)
IN971800AV 4/03
9
7