English
introduction
Congratulations on your purchase and welcome to Philips! To fully
benefit from the support that Philips offers, register your product
at www.philips.com/welcome.
important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
-
Never immerse the motor unit in water or any other liquid, nor rinse it
under the tap. Use only a moist cloth to clean the motor unit.
Warning
-
Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
-
If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
-
Do not use the appliance if the plug, the mains cord or other parts
are damaged.
-
Never use the blender jar to switch the appliance on and off.
-
Never let the appliance operate unattended.
-
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or metal capabilities, or lack of experi-
ence and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
-
Children should be supervised to ensure that they do not play with
the appliance.
-
Do not touch the blades, especially when the appliance is plugged in.
The blades are very sharp.
-
Never reach into the blender jar with your fingers or an object while
the appliance is operating.
-
If the blades get stuck, unplug the appliance before you remove the
ingredients that block the blades.
Caution
general
-
Always unplug the appliance before you assemble, disassemble or make
adjustments to any of the parts.
-
Never use any accessories or parts from other manufacturers or that
Philips does not specifically recommend. If you use such accessories or
parts, your guarantee becomes invalid.
Blender
-
Never fill the blender jar with ingredients hotter than 80ºC.
-
To prevent spillage, do not put more than 1.25 litres of liquid in the
blender jar, especially when you process at a high speed. Do not put
more than 1 litre in the blender jar when you process hot liquids or
ingredients that tend to foam.
-
If food sticks to the wall of the blender jar, switch off the appliance and
unplug it. Then use a spatula to remove the food from the wall.
-
Always make sure the lid is properly assembled on the jar and the
measuring cup is inserted properly in the lid before you switch on
the appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence avail-
able today.
Built-in safety lock
The safety lock ensures that you can only switch on the appliance if you
have properly assembled the blender jar on the motor unit. If the jar is
correctly assembled, the built-in safety lock will be unlocked.
General description (Fig. 1)
1
Measuring cup
2
Lid
3
Blender jar
4
Control knob with pulse setting, off setting and 2 speed settings
5
Motor unit
3101_106_0518_1_DFU-Leaflet_A6_v2.indd 1
Preparing for use
Thoroughly clean the parts that come into contact with food before you
use the appliance for the first time (see chapter 'Cleaning').
Using the appliance
Blender
The blender is intended for fine pureeing, chopping and blending. With the
blender you can prepare soups, sauces and milk shakes. You can also use it
to process vegetables, fruit, meat, pancake batter etc.
Mount the blender jar on the motor unit and turn it clockwise until it
1
locks into position ('click') (Fig. 2).
The blender jar can be mounted in any position.
Put the plug in the wall socket.
2
3
Put the ingredients in the blender jar.
Place the lid on the blender jar (1). Push down the lid and turn it
4
clockwise until you hear a click (2) (Fig. 3).
Insert the measuring cup into the opening in the lid (Fig. 4).
5
Turn the control knob to speed 1 or 2 (Fig. 5).
6
-
Turn the control knob to pulse position if you want to process ingredi-
ents very briefly (Fig. 6).
Do not let the appliance operate for more than 3 minutes at a time.
7
Switch off the appliance and unplug it when you have finished
processing.
8
Clean all removable parts immediately after use.
Tips
-
If you want to crush ice cubes, put not more than 6 ice cubes
(of approx. 25x35x25mm) in the blender jar and turn the control
knob to pulse position a few times.
-
Cut meat or other solid ingredients into smaller pieces before you put
them in the blender jar.
-
Do not process a large quantity of solid ingredients at the same time.
To get good results, we advise you to process these ingredients in a
series of small batches.
-
To make tomato sauce, cut the tomatoes in four and drop the pieces
through the opening in the lid onto the rotating blades.
Measuring cup
You can use the measuring cup to measure ingredients. You can also push a
hole in it for slowly adding oil when you prepare mayonnaise.
Note: When you have pushed a hole in the measuring cup, it can no longer be
used as a measuring cup.
When you prepare mayonnaise:
-
Let the blender operate at a low speed.
-
Add the oil very slowly to obtain the right consistency.
Cleaning
Always unplug the appliance before you clean it.
Never immerse the motor unit in water, nor rinse it under the tap. Do
not clean the motor unit in the dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Unplug the appliance.
1
Disassemble all removable parts from the motor unit.
2
Do not touch the blades. They are very sharp.
Clean the removable parts immediately after use with hot water and
3
some washing-up liquid.
The blender jar, the lid and the measuring cup are dishwasher-proof.
Clean the motor unit with a moist cloth.
4
storage
1
To store excess cord, wind it round the base of the motor
unit. (Fig. 7)
Environment
-
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment (Fig. 8).
Guarantee and service
If you need service or information or if you have a problem, please visit the
Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country. You find its phone number in the worldwide
guarantee leaflet. If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance.
If you cannot find the answer to your question, contact the Consumer Care
Centre in your country.
Question
Answer
Can I clean all re-
Yes, except the motor unit. Only clean the motor
movable parts in the
unit with a moist cloth.
dishwasher?
Can I pour boiling
No, let hot liquids cool down to 80°C to prevent
hot liquids into the
damage to the jar.
blender jar?
Why does the mo-
It is common for a new appliance to give off an
tor produce an
unpleasant smell or emit some smoke the first few
unpleasant smell
times it is used. This phenomenon stops after you
during processing?
have used the appliance a few times. If the appli-
ance has been switched on too long, it may also
give off an unpleasant smell or emit some smoke.
In this case, set the control knob to 0 and let the
appliance cool down for 60 minutes.
The appliance
Set the control knob to 0 and use a spatula to
stopped operating
dislodge the ingredients that block the blade unit.
because the blade
We also advise you to process a smaller quantity.
unit is blocked. What
should I do?
Register your product and get support at
www.philips.com/welcome
HR2009
3101.106.0518.1
21-10-11 10:57