Using The Live Drive App; Downloading The App; Bluetooth Pairing; Live Drive Operation - Alto Professional BLACK 15 Guia Del Usuario

Using the Live Drive App

Black Series loudspeakers also come equipped with wireless technology and the unmatched
capabilities of the Alto Professional Live Drive wireless speaker app. You'll be able to level-match,
adjust EQ and compression, time-align and more. The Black Series puts active live sound control at
your fingertips. Using the app on your iPad or iPhone, you can adapt the speakers to new venues or
tweak settings remotely from any corner of the room. Black Series loudspeakers offer a powerful new
experience, not only for your audiences, but also for you—you get streamlined, sound-shaping
capabilities at your fingertips.

Downloading the App

To download the App, just search for Live Drive in the App Store and download the Alto Professional
Live Drive app.

Bluetooth Pairing

About Range: Black Series loudspeakers use an advanced, extended-range Bluetooth antenna
design, allowing for ranges far greater than traditional Bluetooth devices. The typical range is 60-80
feet (18-24 meters) with a clear line of sight. However, the range may vary depending on your source
device and the environment.
To maximize the range:
•
Set your source device on a flat surface and make sure there are no obstacles between the
loudspeaker and your device (e.g., walls, furniture, etc.).
•
Turn off your source device's Wi-Fi.
•
Turn off any unneeded 2.4 GHz devices in the nearby vicinity (e.g., other Bluetooth devices,
baby monitors, Wi-Fi access points, microwave ovens, etc.).
•
Try using a different Bluetooth source device (iPad or iPhone). Bluetooth signal strength varies
between different devices.
To pair the speaker to your Bluetooth device:
1. Do this on one loudspeaker only: With the loudspeaker powered on, press and release its
Pairing Button. Its Pairing LED will flash, and you will hear a tone sequence from the
loudspeaker.
2. From your Bluetooth device's settings page, enable Bluetooth and select ALTO PRO
WIRELESS TS112W as the device. When paired successfully, you will hear a final "confirmation
tone" from the loudspeaker and the Pairing LED will light continuously. (This process may take
up to 60 seconds.)
Important:
• If your device prompts you to enter a PIN code to pair it to the speaker, enter 0000 (four
zeros).
• If your device prompts you to select the connection type, select "stereo speakers,"
"advanced audio," or a similar option.
3. Once your device is paired to the speaker, the speaker will remember the device even after
power-cycling it. To reconnect it, go to your device's Bluetooth settings page and select
Connect to reestablish the connection.
To erase all previous pairing and linking settings, press and hold the Pairing Button for 3
seconds. You will hear a long tone to confirm its pairing settings have been erased. The LED will also
turn off. Now, you can pair to a new device.

Live Drive Operation

For more information about using Live Drive, tap XXXX in the app to view the Live Drive manual.
6