Setting Temperature; Setting Time; Timer Operation - Sammic SOUS-VIDE Serie Manual Del Usuario

Setting Temperature

1. P r es s and hold t h e d o w n a r r o w for more than 1.5 s eco n d s to
display "SP1" the set temperature.
The 'set temperature' indicator will illuminate.
2. Use u p and d o w n arrow keys to s elect r eq u ir ed t em p er a t u r e . If
the page button is pressed at this time it is immediately acknowledged
and the timer can be set.
3. After setting temperature the display flashes between "SP1" and set
temperature and will automatically revert to show actual liquid
temperature. Heater indicator will illuminate.
4. The Sammic w a t er b a t h is n o w s et a n d w ill h ea t a n d
co n t r o l t h e liq u id a t s et t em p er a t u r e .

Setting Time

1. Repeatedly press FUNCTION button until "t" appears on the display.
It will then alternate between showing "t" and time - displayed as hh.mm
2. Press either up or down arrow to select desired number of hours:minutes.
- Minimum time setting is 0 hours and 01 minutes - displayed as 00.01
- Maximum time setting is 99 hours and 59 minutes - displayed as 99.59
3. Once the desired time is entered press function button to confirm.
Display reverts to actual liquid temperature.

Timer Operation

1. To start timer press and hold RUN button for more than 1.5 seconds.
2. Heating indicator will flash when set temperature has been reached
and is being maintained.
3. The timer indicator starts to flash showing the timer is running.
4. To view time remaining, press UP ARROW button, "t" appears and time
remaining is displayed as h:mm.
5. An audible beeping and "End" message indicates timed period has
finished. Press RUN button to deactivate buzzer and clear "End" message.
If power is interrupted during Timer mode, the displays shows "P.OFF"
when resumed. To clear, press and hold the RUN button until display
reverts to actual temperature. Timer mode will then continue. To
deactivate timer mode, press and hold RUN button.
6
6
7 6