DENTSPLY DP-120H/120V Manual Del Propietario Y Del Operador página 4

INST L TION INSTRUCTIONS:
Shipping damage should be reported to the carrier as soon as detected.
The Unit Package contains the following:
Vacuum Pump
Feet, Four Each
Exhaust Muffler
Inlet Fitting
Owner & Operators Manual
UNP CKING:
Save the box and other packing material for future use in transporting the unit.
• Open the box.
• Carefully lift the unit from the box by lifting on packaging supports. Support unit from the bottom to prevent slipping.
• Remove packaging supports.
• Remove plastic bag.
INST LL TION:
1. Locate the pump below the Vacuum furnace. Mounting of the pump above the furnace will cause any water
condensation in the lines to flow back into the furnace.
2. Remove plastic covers from inlet and exhaust ports. Screw in the inlet fitting (tightly to achieve optimum vacuum) and
exhaust muffler before operating the pump. The pump may be damaged if covers are not removed.
3. Install feet and tighten using the provided nuts.
4. The pump should be mounted horizontally.
5. Connect the vacuum line from the furnace to the inlet of the pump.
(a) Force the tubing over the inlet fitting.
6. Connect the pump's power cord into the electrical outlet on the back of your DENTSPLY Prosthetics furnace. This will
allow the furnace to operate the pump when vacuum is called for in a cycle.
Inlet
W RNING:
Do not use extension cords with this equipment.
Plug the power cord into a circuit rated a minimum of 15 .
4
Exhaust Port