Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid damaging the light modules, it is recommended that wiring be performed before
1b. Integral Surface Mounting.
The Model LSB is also designed for surface mounting installations on machines, cabinets,
control boards or any installation where a rigid flat surface is
available. The LSB is four inches high and contains the wiring, in-
terconnects and the flasher (120VAC unit only). The LSB has four
flashed over holes and includes four sheet metal screws.
Install the Model LSB as follows:
a. Remove the base top wiring.
b. Drill the large clearance hole using a 1" hole saw.
c. Place the base onto a flat section and align the wire exit hole
with the 1" drilled hole.
d. Drive the supplied sheet metal screws through the recessed holed in the bottom of the
base.
e. Replace the base top and wiring.
2. Reduced Profile Surface Mounting.
The model LSBS is designed for reduced profile surface mounts. Using the LSBS gives
the installer the same mount configuration as the LSB, but is only 1/4 inch in height. All of
the wiring and interconnects when using LSBS will reside below the surface in the users'
enclosure.
The LSBS includes: a Mounting Gasket, a base Mounting Ring
and four screws, a base Top with wires, and a Cap Kit with riv-
ets.
Install the Model LSBS as follows:
a. Place the gasket onto a flat section of the surface at the de-
vice's intended location.
b. Mark the four mounting holes and the center clearance hole.
c. Using the gasket as a guide, drill the four mounting holes us-
ing a #24 drill. In the center of the 4 hole pattern, drill the
large clearance hole using a 2-1/2" hole saw.
d. Locate the gasket on the surface and place the mounting ring with the base top and wir-
ing in place on the gasket. Secure the unit with the supplied #8 self-tapping screws.
Excessive torque on the mounting screws may crack the base Mounting Ring.
After the base is installed, the light modules are assembled on the base. At least one, and up to
five light modules may be assembled on the base in any sequence (determined by the user).
To avoid damaging the light modules, it is recommended that wiring be performed
C. Power Requirements.
(Incandescent load with 5 light modules or load with 4 light modules and 1 Sound module):
24V, 0.76 per module, 3.8A max.
120V, 0.225A per module, 1.13A max
Individual module Power Requirements:
1 Lamp module (LSL) 0.76A, 24VDC
CAUTION
assembling the light modules on the base.
CAUTION
Do not over tighten the screws.
CAUTION
before assembling the light modules on the base.
-2-
290A3801
290A3795
Publicidad
