Karaoke
•
Plug the microphones (included) into the MIC jacks.
•
Adjust the mic volume with the knobs on the back, adjust reverb with the ECHO knob.
•
Chose your preferred device mode and start playback. Sing!
BT
•
Turn off the BT functionality of other devices that are already paired with your unit.
•
Press MODE button to select BT mode.
•
Turn on BT functionality on your BT device.
•
Choose ‚add a new BT device' or ‚setup BT device' on your device. It will start to search.
Once „TALLBOY" / „TALLGIRL" shows on your device, select it. If your device prompts you
for a pass code, please enter „0000". If the pairing attempt fails or times out, please start
pairing procedure again.
•
After your device and the tower have connected each other, a sound can be heard.
•
Make sure the BT connection between the unit and the device is active.
•
Press Play/Pause button to pause playback, press again to resume playback.
•
Press button to skip forward to next track and to skip backward to previous track.
LEDs
•
Turn the LEDs on/off with the LED switch on the rear (14). In the upper switch position,
the music sensitivity is high, in the lower position the sensitivity is low. Middle position:
LED light effects off.
According to the European waste regulation 2012/19/EU this symbol on the
product or on its packaging indicates that this product may not be treated
as household waste. Instead it should be taken to the appropriate collection
point for the recycling of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise
be caused by inappropriate waste handling of this product. For more detailed
information about recycling of this product, please contact your local council
or your household waste disposal service.
Manufacturer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European directives:
2014/53/EU
(RED)
2011/65/EU
(RoHS)
Environment Concerns
Declaration of Conformity
13