Nilfisk SDV 8000 Manual De Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
Technical
Boiler
Wattage:
3000W – (2000+1000)
Type:
Stainless Steel
Capacity:
3.3 Litres
Continuous Fill
Steam Pressure:
8 Bar
Steam at source:
165°C >
Vacuum
Type:
Integral
Motor:
850 Watt
Electrical
Voltage:
230V ~ single phase
Low Voltage Controls:
5V
Cord length:
10m
Capacities
Boiler:
3.3 Litres
Cold Water Tank:
5 Litres (easy fill)
Collection Tank:
12 Litres
Detergent Tank:
2.5 Litres (easy fill)
Weight:
35kg
English
Trouble
Shooting
No Power
Not connected
Check
or faulty
connection to
power cable
wall socket and
socket switch.
Try in another
wall socket
On / Off
Press On / Off
switch not on
switch which
will illuminate
when on
Fuse blown
Replace fuse
with approved
13A fuse
Unknown
Call for service
No steam
Steam Control
Turn the
turned down
control to half
fully
way
clockwise
Steamer not
Wait for the
ready
"Ready to
steam" light to
illuminate
Clean water
Pour water into
tank is low
the clean water
(beeping
tank until the
sound&
beeper stops.
"refill" light is
The steam
lit)
handle will
work again.
Unknown
Call for service
No steam, Just water
Steamer not
Wait for the
ready
"Ready to steam "
light to illuminate
Boiler at
Hold the steam
pressure
switch on for
and not
approximately
heating(tem
one minute, ever
perature
if just water is
less than
coming out. This
110ºC)
will result in the
heater coming
back on
Unknown
Call for service
Page 8
Steam Leaking from
front socket
"O" Rings
Change and re
split
grease "O" Rings.
To avoid this
happening ensure
"o" rings are grease
before every use.
"O" rings
Change and re
worn
grease "O" Rings.
To avoid this
happening ensure
"o" rings are grease
before every use.
Vacuum power low
Vacuum
Operate any of the
operation
handle controls,
has been
which will reset the
selected
motor power to full.
on the
Continue
machine
vacuuming
High pitch
Switch the machine
motor
off and empty the
noise
collection tank.
Refill the collection
tank with clean
water to the mark
and recommence
work.
Unknown
Call for service
No detergent
Solution tank
Pour cleaning
empty
solution diluted
in accordance
with the
manufacturer's
instructions into
the solution
tank.
Unknown
Call for service

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido