AVS Electronics OUTSPIDER PA Manual De Instrucciones página 42

Ocultar thumbs Ver también para OUTSPIDER PA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installazione Antistrappo
With joint
E
Point for
N
inserting tamper
G
Fixing the base to the plate
w
For OUTSPIDER PA and OUTSPIDER DT connect the tamper
module to the negative power supply and to the specially
configured AUX input (see DIP 6 and DIP 8 from panel SW2)
w
In OUTSPIDER PA WS(UB)(U) and OUTSPIDER DT
WS(UB)(U) connect the tamper module to the dedicated
terminals T T
Have the wires exit
the anti-tampering
module from the
side notch
Punto di fissaggio
modulo tamper
Presettings for access of connection
wires
1.
Hook the base of the sensor to the two
stops on the lower portion of the metal plate
2.
Fix the base of the sensor to the metal
plate using the two screws provided
Fixing the base to the joint
Adhesive sponge-
rubber to apply onto
the bottom before
fixing the swivel
Con piastra
Knock out hole for
connection cable
access
Screws supplied
for fixing the
sensor to the joint
- 42 -
To break for using th
swivel
Knock-out holes for
fixing the base of
the sensor to the
For installation
with joint, do not
use the metal plate
on the bottom of
the sensor
joint

Publicidad

Tabla de contenido
loading

Tabla de contenido