Using Dv Pass-Through For Digital Camcorders - ADS TECH PYRO A/V Link Manual Del Usuario

Using DV Pass Through for Digital Camcorders
If you wish to connect your Digital Camcorder to the 4 Pin 1394 port on the front
of the PYRO A/V Link, you will need to make some additional settings to ensure
that you can control your camcorder via the Video Studio software. Device
control will include Start, Stop and Record functions on your digital camcorder.
Follow the steps below to properly setup your Digital Camcorder for 1394
pass-through with PYRO A/V Link.
1.) Click on "File"
2.) Click – "Select Device Control"
3.) Select the camcorder driver;
"MS 1394 Device Control"
4.) Then click on "Options"
5.) Select your Digital Camcorder
as the active device
6.) Click "OK" to close the dialog boxes
You now should now see your digital
camcorder listed in the Source window
on the capture settings panel.
7.) Be sure your camcorder is turned
on and set to VCR/VTR mode
8.) Press "Play" below the Preview Window
and your camcorder should begin
playing and video will begin playing in
the preview Window
PYRO A/V LINK 35