Connecting To The Network - Worldcast Systems AUDEMAT FM MONITOR Silver Guía Rápida

3. Connecting to the network

1. Connect the unit to the power using the power supply cable.
2. Connect the RF input of the equipment to the antenna (not provided).
3. Connect the Ethernet cable from the secondary interface of the AUDEMAT FM Monitor Silver to
your PC *, or to a router or a switch.
* With a direct connection, you will need to set an IP
address on your PC in the 172.17.2.xx range, so both are
compatible.
With Windows Vista / 7 / 8 / 10, go to:
 Control panel / Network and Internet / Network and
Sharing Center.
 Click on "View Status" for your local area connection,
and on Properties
 Click on Internet Protocol 4, then on Properties.
 Add the IP address and the sub-net mask (for
example 192.168.0.56 / Netmask 255.255.0.0).
4. Press the "power" button

Wait for the unit to reboot (approximately 1 minute).
Note: the second interface is used for the initial connection. Please read the manual for more details
on setting you unit.
English version
5