Publicidad
Parts Included
A. Sliding Basket Assembly
B. (4) Mounting Screws
A
B
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16˝(1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
MUB-11-R-FN
MUB-14-R-FN
MUB17-FN
2700 Oak Industrial Drive NE, Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
Multi-Use Baskets
Installation Instructions
Inspect all parts and read all instructions prior to
beginning assembly and installation.
With a pencil make a mark 1-1/4" back from the front outside edge of the cabinet.
1
Place the sliding basket assembly with the front edge of the front mounting strap
directly behind this line. With a pencil mark the cabinet floor through the front two
mounting hole locations. Remove the basket from the cabinet. With 1/16" drill bit drill
pilot holes through the two mounting hole locations you marked.
Pull the multi-use basket completely forward. Place the entire assembly back inside of
2
the cabinet so that the front mounting holes line directly over the pilot holes you drilled
in the cabinet floor. Fasten the front mounting strap to the cabinet floor using two
mounting screws.
Now that the front mounting strap is mounted to the cabinet floor drill pilot holes
3
in through the rear mounting hole locations with the 1/16" drill bit. Fasten the rear
mounting strap to the cabinet floor using two mounting screws. Push the multi-use
basket all the way back into the cabinet. Installation is now complete.
1
1-1/4"
(3.2 cm)
3
©2013 Knape & Vogt. All rights reserved.
Knape & Vogt
reserves the right to change specifications without notice. Made in China.
®
2
310243_C_0413
Publicidad
