Making The Electrical Connections - HAMPTON BAY E503-WH Guía De Uso Y Cuidado

DPA12122006 新版 SIZE:216x280mm 80g模糙纸 24P 单黑色 骑马钉 2013-4-17 第 8／24页
5

Making the electrical connections

Connect the 9 pin connector (2) from the fan motor (G) to
the 9 pin connector (2) from the receiver (F).
Connect the green ground wire (II) from the receiver (F)
to the green wire (II) from the outlet box (1) using a wire
connecting nut (HH).
Connect the white wire (JJ) from the receiver (F) to the white
wire (JJ) from the outlet box (1) using a wire connecting
nut (HH).
Connect the black wire (KK) from the receiver (F) to the black
wire (KK) from the outlet box (1) using a wire connecting
nut (HH).
KK
1
KK
F
2
from the fan motor (G).
JJ
II
II
JJ
II
2
6
Attaching the upper housing to
the fan motor
Remove one of the preassembled upper housing
screws (GG) from the fan motor (G). Loosen, but do
not remove, the other two upper housing screws (GG).
Ensure the upper housing (H) screw covers (1) are in
the full open position.
Raise the upper housing (H) up to the ceiling and slide
the slotted hole in the upper housing (H) through the
loosened upper housing screw (GG), and twist the upper
housing (H) to lock it in place on the screw (GG). Tighten
all three screws (GG) securely with a Phillips screwdriver,
and close all three screw covers (1).
GG
G
GG
8
GG
1
H
GG
1
H