ASROCK M3A770DE Manual Del Usuario página 17

TM
CrossFire Bridge
Step 4. Connect the DVI monitor cable to the DVI connector on the Radeon graphics
card on PCIE2 slot. (You may use the DVI to D-Sub adapter to convert the DVI
connector to D-Sub interface, and then connect the D-Sub monitor cable to the
DVI to D-Sub adapter.)
Step 5. Power on your computer and boot into OS.
TM
Step 6. Remove the ATI
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please check AMD website for ATI
Step 7. Install the required drivers to your system.
For Windows ® XP OS:
TM
A. ATI recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center. Please
check Microsoft website for details.
®
For Windows Vista
Install the CATALYST Control Center. Please check AMD website for details.
Step 8. Restart your computer.
Step 9. Install the VGA card drivers to your system, and restart your computer.
Then you will find "ATI Catalyst Control Center" on your Windows
ATI Catalyst Control Center
ASRock
driver if you have any VGA driver installed in your system.
TM driver updates.
®
XP Service Pack 2 or higher to be
®
XP Service Pack 2 or higher installed
TM
OS:
M3A770DE Motherboard
®
taskbar.
1 7 1 7 1 7
1 7 1 7