Operation; Turning On The Appliance; Adjust The Suction Output; Working With Electrical Power Tools - Baier Elektrowerkzeuge BSS 508-M Manual De Instrucciones

Close the suction connection
Illustration
 Precisely fit the plug into the suction
connection.
 Insert the plug up to the stop.
 Tightly close the suction connection
with the plug by turning it to the right.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Remove the fleece filter bag
Illustration
 Release and remove the suction head.
 Pull the fleece filter bag (special acces-
sories) towards the rear.
 Fold in the lock latch and tightly close
the fleece filter bag (special accesso-
ries).
 Dispose of the used fleece filter bag
(special accessories) in a dust-tight bag
according to statutory provisions.
 Insert and lock the suction head.
– When vacuuming up wet dirt, the fleece
filter bag (optional accessory) must al-
ways be removed.
Removing the dust disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Pull the opening of the disposal bag out
toward the back over the suction sup-
port.
 Tightly seal the disposal bag with clo-
sure strips underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according
to the local provisions.
 Insert and lock the suction head.
– To suck wet dirt, always remove the dis-
posal bag.
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.

Turning on the Appliance

 Plug in the mains plug.
 Switch on the appliance at the main
switch.

Adjust the suction output

 Set the suction output (min - max) at the
rotary switch.

Working with electrical power tools

DANGER
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
 Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch on the appliance at the main
switch.
Indicator lamp is on; vacuum cleaner is in
the standby mode.
Note: The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Note: The vacuum cleaner starts automat-
ically within 0.5 seconds and continues to
run for 15 seconds after the power tool has
being switched off.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
 Connect the tool adapter to the electric
power tool.
– 4
EN

Operation

17