Electrical Preparation; Electrical Supply - BSH SHUC Serie Instrucciones De Instalación

7
Remove the hose hanger clip and hanger label at the back of the dish-
washer as shown above.
Do not work on an energized circuit. Doing so could result in serious
injury or death. Only qualified electricians should perform electrical
work. Do not attempt any work on the dishwasher electric supply
circuit until you are certain the circuit is de-energized.
To avoid possible injury or property damage, care should be exer-
cised when the dishwasher is installed or removed to reduce the
Make sure electrical work is properly installed. Only qualified
Make sure there are no loose electrical connections. Make sure all
The customer has the responsibility of ensuring that the dishwasher
electrical installation is in compliance with all national and local electrical
codes and ordinances. The dishwasher is designed for an electrical sup-
ply of 120V, 60 Hz, AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breaker rated for 15 amps. Elec-
trical supply conductors shall be a minimum #14 AWG copper wire
rated at 75°C (167°F) or higher.
10
REMOVE
THIS TAG BEFORE INSTALLATION
RETIRER
CETTE ÉTIQUETTE AVANT L'INSTALLATION
Important Information
Route the hoses through the left or right hand
side traps. Refer to installation guide for details.
Information importante
Faites passer les tuyaux par le collier de gauche ou
de droite. Consultez le guide d'installation
pour les détails.

Electrical Preparation

WARNING
Avoid Electrical Shock Hazard
likelihood of damage to the power cord.
Avoid Fire Hazard
electricians should perform electrical work.
electrical connections are properly made.

Electrical Supply