Operating Lock; Programming The Heating Profiles - Alpha IP RTD 61001-N1 Manual De Instrucciones

Operating modes and configuration

6.1.4 Operating lock

The operation at the device can be locked in order to prevent the unintentional
change of settings e. g. by accidental touch. Proceed as follows in order to activate
or deactivate the operation lock:
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol " " and confirm the selection by shortly pressing the setting
wheel.
3. Select "ON" by turning the wheel in order to activate the operation lock, or
"OFF" in order to deactivate the operation lock. Confirm the selection by press-
ing the wheel shortly.
6.1.5 Programming of heating profiles
This menu item allows to make settings for heating or cooling profiles and the cre-
ation of week profiles according to own requirements.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
wheel.The following subordinate menu items are available in the menu, to be
accessed by turning the wheel:
"type" for switching over the base station between the modes Heating and Cool-
ing.
1. Turn the setting wheel (E) to "HEAT" for heating or "COOL" for cooling and
confirm by shortly pressing the wheel.
44
" and confirm the selection by shortly pressing the setting