Wiring The Loudspeaker; Wiring Terminals; Amplifier Output Connection - Bose Professional FreeSpace 3 Serie Guia De Instalacion

Setup

Wiring the Loudspeaker

Wire Gauge
FreeSpace 3 loudspeakers are designed to work with 18 AWG (0.8 mm

Wiring Terminals

Series II Acoustimass bass module: Remove the
rear cover plate to access the wiring terminals.
Reattach the rear cover plate after completing all
wiring connections.

Amplifier Output Connection

CAUTION: Complete all wiring connections before connecting an amplifier to power or powering it on.
100V
Transformer Tap Settings
The transformer tap is set at the factory for 200W use. To set it for a lower wattage, remove the end of the + jumper wire that is connected
to the 200W terminal and reattach it to the appropriate tap: 100W, 50W, or 25W.
Note: The jumper wires are required for 70V/100V operation. For 6Ω operation (transformer bypass/direct), remove both jumper wires.
6 • English
) to 14 AWG (2.1 mm
2
Flush-mount Satellites: Remove the
rear cover plate to access the wiring
terminals. Reattach the rear cover
plate after completing all wiring
connections.
70V
200W
) size wire only.
2
Surface-mount Satellites: Push and
hold the button on the rear panel while
inserting the wire to insert the wire fully.
70V in parallel
100W
50W
25W
FreeSpace 3 Loudspeaker System • Installation Guide
PRO.BOSE.COM
(second bass
module)