Getting Started - Victure AC400 Manual Del Usuario

Getting Started

Charging
To charge, connect one end of the included micro-USB cable to a power adapter
or a USB charging port and the other end to the micro-USB port on the camera.
When you connect the camera to the power, the camera will automatically turn
on. To more effectively charge the camera, turn it off. The red charging indicator
will stay on when the camera is charging and turn off when the camera is fully
charged. Charging with the power adapter takes around 3 hours.
Turning the Camera On/Off
Press and hold the power button for 2 seconds to turn the camera on/off. When
the camera is turned on, the two LED status indicators will light up and the
display will turn on.
Using a Micro SD Card
The camera does not include internal storage and requires a micro SD card
(Class10 + recommended and 32GB Max supported) to function. Use a
high-quality, branded card for maximum reliability. Insert a micro SD card into
the micro SD card slot and format it ( 'Format' in camera system settings) to
prepare the card for use. Formatting will permanently erase any data on the
micro SD card.
Camera Modes
Press the mode button to cycle through video, photo,burst photo, time lapse
and setting mode. Press down button to go to playback mode.
Video Mode: Press the OK button to start or end recording. When the
camera is recording, the LED status indicators flash once every 2 seconds.
When it stops recording, the LED status indicators stay on.
Photo Mode: Press OK button once to take photos.
Burst Photo Mode: Press OK button once to take 3 photos in 1.5 seconds.
Time Lapse Photo Mode: Press OK button to take a photo after a set
time (you can set 2, 3, 5, 10, 20, 30, or 60-second timings in settings). Take
a series of photos automatically at the set interval by turning on the
'continuous lapse' setting and pressing OK button once (cancel by
pressing again).
3