Bose Professional Panaray MSA12X Serie Guia De Instalacion página 3

pro.Bose.com
WARNINGS/CAUTIONS:
• To prevent injury, this apparatus must be securely attached to the wall in accordance with the installation instructions.
• All Bose products must be installed in accordance with local, state, federal and industry regulations. It is the installer's responsibility
to ensure installation of the loudspeakers and mounting system is performed in accordance with all applicable codes, including local
building codes and regulations. Consult the local authority having jurisdiction before installing this product.
• Unsafe mounting or overhead suspension of any heavy load can result in serious injury or death, and property damage. It is the
installer's responsibility to evaluate the reliability of any mounting method used for their application. Only professional installers with
the knowledge of proper hardware and safe mounting techniques should attempt to install any loudspeaker overhead.
• Do not mount the product in locations where condensation may occur.
• This product is not intended for installation or use in indoor water facility areas (including, without limitation, indoor pools, indoor
water parks, hot tub rooms, saunas, steam rooms and indoor skating rinks).
• To reduce the risk of fire or electrical shock, do NOT expose this product to rain, liquids or moisture.
• Do NOT expose this product to dripping or splashing, and do not place objects filled with liquids, such as vases, on or near the
product.
• Keep the product away from fire and heat sources. Do NOT place naked flame sources, such as lighted candles, on or near the
product.
• Do NOT make unauthorized alterations to this product.
• Do NOT use a power inverter with this product.
• Do NOT use in vehicles or boats.
• The speaker wire and interconnect cables included with this system are not approved for in-wall installation. Please check your local
building codes for the correct type of wire and cable required for in-wall installation.
• Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
• The MSA12X wall mounting kit is only for use with model MSA12X.
• Only use the mounting hardware supplied with this product.
• Do not mount on surfaces that are not sturdy, or that have hazards concealed behind them, such as electrical wiring or plumbing.
If you are not sure about installing the bracket, contact a qualified professional installer. Ensure the bracket is installed according to
local building codes.
• Bose recommends using a safety cable, even if one is not required.
• Due to ventilation requirements, Bose does not recommend placing the product in a confined space such as in a wall cavity or in an
enclosed cabinet.
• Do not place or install the bracket or product near any heat sources, such as fireplaces, radiators, heat registers or other apparatus
(including amplifiers) that produce heat.
Product Ratings:
~
Input Voltage: 100-240 V
Frequency: 50/60 Hz
Power: 200 W (600 W total)
~
Output Voltage: 100-240 V
Frequency: 50/60 Hz
Current / Power: 4 A / 400 W
FCC Compliance Notice for US
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at theirown expense.
Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate this equipment.
This product meets all EN55103-2 immunity requirements for E2 electromagnetic environment.
This product complies with the Canadian ICES-003 Class A specifications.
CAN ICES-3(A)/NMB-3(A)
This product conforms to all applicable EU directive requirements. The complete declaration of conformity can be found at:
www.Bose.com/compliance.
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection
facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more
information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you
bought this product.
Important Safety Instructions
Important Safety Instructions - 3