Indel B CRUISE 49 Instrucciones Para El Uso página 17

W I R I N G SYS TE M
To operate the refrigerator on the vehicle battery, please refer to the instruction manual of the
vehicle's manufacturer.
W I R I N G SYS TE M : FU N C TI O N S A N D FE ATU R E S ( W ITH
AU X I LIA RY BAT TE RY )
The electronic control unit of the compressor is an electronic equipment which controls the
motor of the compressor, takes care about the system and protects the electrical components.
Its main features are the following:
Protection of the battery with automatic turning off of the compressor when the supply voltage
reaches the minimum threshold (cut out).
The compressor will start up automatically again when the voltage goes back to normal values (cut in).
TABLE FOR BATTERY SAVER TRIPPING VOLTAGES
FEEDING
12 V
24 V
W I R I N G CO N N EC TI O N S
When you connect the refrigerator, you must remember the following:
1) Use cables having the proper cross section (see table) to make the feeding lines. If possible,
such cables should be without any joints on the leads which could lead to voltage drops.
2) If the wiring system of the vehicle is insufficient or not properly sized for the refrigerator,
connect it directly to the battery without using intermediate wiring.
3) Any switches must have a breaking load not less than 20 A.
4) Make sure the polarity is right: connect the red cable to the positive terminal (+) and the black
cable to the negative terminal (-).
5) Protect the feeding line with a 15 A fuse.
WARNING
The use of cables having an insufficient cross section may lead to the compressor stopping
even when the battery is charged.
C ROS S S EC TION
CAB LES M M
2,5
4
6
10
WARNING
Never Connect non insulated cables, and use only connectors of a size suitable to the cross
section of the cable being used.
CUT OUT
9,5 V
21,3 V
MAXIMUM LENGT H OF CABLE S IN ME TE RS
2
12V
2,5
4
6
10
CUT IN
11 V
22,7 V
24V
5
8
12
20
15